Manually Restarting HPE Ezmeral Container Platform Services

This topic describes restarting HPE Ezmeral Container Platform services in non-Kubernetes hosts.

To manually restart HPE Ezmeral Container Platform services:

1. Log in to the web interface as a Platform Administrator, as described in Launching and Signing In.
2. Determine which host is the Controller host (see Controllers Tab). If Platform High Availability protection is enabled (see High Availability), then also determine which hosts are the Shadow Controller and Arbiter.
3. Log in to the Controller host as either root or the ID that was used to install HPE Ezmeral Container Platform.

4. If Platform High Availability protection is enabled, then execute the following command to suspend this protection:

   /opt/bluedata/bundles/<epic install bin folder>/startscript.sh --action suspendha

5. Execute the following commands on every host except Gateway hosts to shut down services:

   systemctl stop bds-monitoring
   systemctl stop bds-worker
   systemctl stop bds-controller

   NOTE

   The name controller in the service name bds-controller may be misleading, as it runs on both the Controller and Worker hosts.

6. On every host (including the Controller), bring the services up in the following order:

   systemctl start bds-cgroup

   This step is only needed after a system reboot.

   systemctl start bds-worker
   systemctl start bds-controller
   systemctl start bds-monitoring

7. Within each host, verify that the following services are up and running:

   systemctl status bds-worker
   systemctl status bds-controller
   systemctl status bds-monitoring

8. If applicable, re-enable platform High Availability protection by executing the following command on the Controller host:

   /opt/bluedata/bundles/<epic install bin folder>/startscript.sh --action resumeha