Post Installation Steps

Provides steps to complete after you install HPE Ezmeral Unified Analytics Software on user-provided hosts.

After you have successfully installed HPE Ezmeral Unified Analytics Software, complete the following post installation steps:
  1. Note the ingress node IP address on the Installation Status screen and configure or update your DNS A records to point to this address.
    NOTE
    If you do not see the IP address, refer to the User Interface troubleshooting page to resolve the issue.
  2. Update A records in your DNS server to resolve your domain name with the addresses provided. You can do this by pointing your DNS record to the two IP addresses that display on the Installation Status screen. It may take a few minutes for your DNS settings to propagate.
  3. Access the HPE Ezmeral Unified Analytics Software home page by clicking the green bar that reads Open HPE Ezmeral Unified Analytics Software.
  4. Note the Platform ID in the window. You need the Platform ID to activate the HPE Ezmeral Unified Analytics Software service.
  5. To activate the HPE Ezmeral Unified Analytics Software service, follow the steps listed in Service Activation and Billing in Connected Environments.
  6. (Air-gapped environments only) For a successful Airflow installation, manually set the HTTP proxy or configure Airflow to point to your internal GitHub repository, as described in Airflow DAGs Git Repository. This step is required in an air-gapped environment because Airflow is pre-configured to pull DAGs from an HPE GitHub repository. In air-gapped environments, Airflow cannot access the HPE repository.
  7. Run the following command to update the SPIFFE CSI driver:
    kubectl -n spire set image ds spire-spiffe-csi-driver  spiffe-csi-driver=ghcr.io/spiffe/spiffe-csi-driver:0.2.5
    For details, see Host (Node) Management.